Whirlwind DIR

Cajas Directas. Director, Esta caja directa convierte señales Line, Instrumento o Speaker en una señal de baja impedancia balanceada mic level.
Descripción

Esta caja directa convierte señales Line, Instrumento o Speaker en una señal de baja impedancia balanceada mic level.

INPUT (1/4" jack)
For input of the signal from the source. The source may be the output of any type of musical
instrument or amplifier speaker output. (WARNING! In speaker mode, the Director does not supply the proper
amplifier load required by most tube type amplifiers. Do not use a tube amplifier s speaker output alone with the Director.
You must also have a speaker or appropriate dummy load connected to avoid possible damage to the amplifier.
OUTPUT (1/4" jack)
A "Y" connection or "loop through" from the input.
OUTPUT (XLR jack)
A male XLR, provides a balanced low impedance (150 Ohms) signal for connection to
balanced, low-Z equipment (mixing console, workstation, etc.)
INST/AMP (Switch)
Most instruments will operate properly when set to the INST position. Set to the AMP position
for use with very "hot" instrument signals or when connecting the Director to the speaker output
of an amplifier.
FLAT/FILTER (Switch)
Engages a high-cut filter when used in the FILTER position to reduce hiss and noise. This
filter is functional only when the INST/AMP switch is in the AMP position. Filter is bypassed
when set to the FLAT position.
GND/LIFT (Switch)
Disconnects the ground between the input and the XLR output when set to the LIFT position
to help eliminate hum. Ground remains connected when set to the GND position.